The DP1CS desk panel is a perfect choice for a wide range of desks and workstations with a demand for a panel with height read-out.
The up and down buttons have been made extra “user-friendly” as they are shaped “according to the function”, meaning the user can feel the difference and it is not necessary to look when operating the system.
The DP1CS has a display for height read-out in either cm or inches. The display switches off when not in use, thereby saving power in standby mode.
As an extra feature, the panel can be used for diagnostics as error codes can be displayed.
The desk needs to be initialised.
Follow the procedure shown in the video.
Possible problem: Mains not connected to the control box
Try/Solution: Try to connect a lamp or similar to the mains supply to check whether there is adequate supply voltage.
Possible problem: Are plugs mounted correctly in the control box or to the leg?
Try/Solution: Check all connections.
Possible problem: Are there any visible damages on cables, controls, the control box or legs?
Try/Solution: Damaged parts must be exchanged. Contact the company that sold you the desk.
The desk cannot be raised if it has not been initialised.
If error code 'E01' is shown in the display, the desk must be initialised.
How to initialise your desk:
Now the desk can be raised.
Watch and learn how to easily clean your LINAK desk panel/switch in this short instruction video: How to clean it; which cleaning agents to use; and, last but not least, what you need to pay attention to.
Clean your desk panel with a soft damp cloth. Universal cleaning detergents may be used.
To disinfect the desk panel, use a 70% isopropyl alcohol either as a wipe or add a small amount to a soft cloth.
Warnings
The desk panel is not a sealed unit and there are electronics inside it. If liquids or moisture get into an opening, the PCB may be damaged, and the desk panel ruined.
So:
Alkaline and acidic cleaning agents may, over time, decompose the housing. Hand sanitiser gel may deposit on the desk panel buttons. Over time, the buttons may get stuck, or they may not work properly.
The desk cannot be raised if it has not been initialised.
If the display shows error code 'E01', the desk has not been initialised.
How to initialise your desk:
Change the height in the display to the correct height of the desk by following the procedure shown in the video or described below.
How to set the height of your desk (DP1C and DPT)
Measure the height of your desk from floor to the upper edge of the desktop.
Favourite positions for sitting and/or standing can be stored. Follow the procedure shown in the video or the instructions below.
How to store a position
The position has now been stored.
To move your desk to the stored height, press the memory button until it reaches the stored position.
The system has set a new end-stop outwards.
To reset a saved position, the desk must be re-initialised. Follow the procedure shown in the video.
